Fujitsu ScanSnap iX1400 Basic Operation Manual page 72

No. Name
6 [Scan] button (*1)
7 Wi-Fi indicator
8 Stacker
*1: When the ScanSnap has turned off automatically because of the automatic power off function,
either press the [Scan] button (this will not start scanning), or close the ADF paper chute (cover),
then open it again to turn the ScanSnap back on.
For details, refer to
S1300i)" (page 100).
Back
No. Name
9 Tape seal
10 Security cable slot
11 Power connector
12 USB connector
13 Ventilation port
14 WPS button
15 Wi-Fi switch
Description
Starts scanning. Can be pressed even when the stacker is closed.
Indicates the status of the ScanSnap as follows:
Blue (lit): Ready
Blue (flashing): Scanning
Orange (flashing): Error
Indicates the connection status between the ScanSnap and your
wireless access point as follows:
Blue (lit): Ready
Blue (flashing): Standby
Orange (lit): Not Connectable
Orange (flashing): Not Connectable (WPS error)
Open to use the stacker.
Stacks up the ejected documents.
"Automatic Power OFF (iX1600 / iX1500 / iX1400 / iX500 / iX100 / SV600 /
Description
Remove this tape seal after installing the software.
Used to connect an anti-theft security cable (commercially available).
Used to connect a power cable.
Used to connect a USB cable.
Holes for ventilating hot air from inside the ScanSnap.
Press this button to connect to a WPS compatible wireless access
point by using the push button method.
Turn this switch on to connect the ScanSnap to a wireless LAN.
9
10
11
12
13
14
15
72
Parts and Functions