Installation Instructions - Stainless Steel Installation
STEP 4 INSTALL ANTI-TIP BRACKET (cont.)
• Gently pull back at the ends of the plastic straps to make
the channel rest flush behind the wall.
• Hold the ends of the straps in one hand and slide the plas-
tic cap along the straps until the flange of the cap is flush
with the wall.
Cap
• Place your thumb between the plastic straps and bend up
and down to snap the straps off at the wall.
Install Screws and Bolts:
• Have someone hold the wall bracket centered in place with
each of the holes aligned with the correct opening in the
bracket and level with the horizontal line.
• Insert the lag screws through the bracket and into the stud.
Tighten with a wrench.
Lag Screw
Anti-Tip Wall Bracket
Insert the bolts into the toggle by hand until snug. Tighten
with a wrench.
Bolt
Anti-Tip Wall Bracket
Wood Stud
Drywall or
Steel Stud
Wall Toggle
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out
to remove.
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out
to remove.
•
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible,
do so now.
46