Step 4. Anti-Tip Procedures - Monogram ZIFS360NHRH Installation Instructions Manual

Installation Instructions - Standard Installation
STEP 4 INSTALL ANTI-TIP BRACKET
WARNING
The unit is top-heavy and must be secured to prevent the
possibility of tipping forward.
AVERTISSEMENT
L'appareil ménager est beaucoup plus lourd en haut et il
faut le maintenir en place pour éviter la possibilité de son
basculement vers l'avant.
• The kit supplied with the unit contains 2 lag bolts and 4
toggles with bolts. The wall bracket will be attached to
the wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
• Measure up 81 1/2" from the floor. Mark this point on the
wall.
• Using a level, draw a horizontal line on the wall at this
height.
• Locate at least 2 studs on the back wall. Mark these
points on the horizontal line.
• Place the bottom of the wall bracket with tabs on the
horizontal line. Align the center notch on the bracket
with the center line on the wall.
Tip Over Hazard.
Risque de basculement
STEP 4 INSTALL ANTI-TIP BRACKET
(cont.)
• The anti-tip wall bracket has a series of holes. Select 2
holes that match with the located studs. Make sure the
holes selected are on the center of the studs. Mark the
wall at these points.
Two Additional
Hole Locations at
Ends of Brackets
• Mark an additional hole at each end of the bracket. If one
of the studs is closer to the end of the bracket, mark an
additional hole towards the center of the bracket.
Line on Wall
• Drill 1/2" holes into the wall board at the locations
marked for the toggles to be mounted (not the stud
markings).
• Drill 3/16" holes into wooden studs where marked. If steel
stud construction, drill 1/2" holes into the studs where
marked. You will use 2 toggles with the metal studs.
14
Wall Bracket
Center
Line On Wall
Wall Studs
Center