Step 7 Adjust Door Swing; Step 8 Install Grille Panel - Monogram ZIFS360NHRH Installation Instructions Manual

Installation Instructions - Flush Installation

STEP 7 ADJUST DOOR SWING

NOTE: This appliance has a 3-position door stop. When
space does not allow the door to swing open fully to
115°, you may change the door swing to a 90° opening.
Skip this step if door opening is satisfactory for your
installation situation.
Pin Location
for 90°
Door Swing
• Open the grille to view the top hinge. Note the door
stop pin locations. The pin is factory-installed in the
115° position.
• Close the door. Use Pliers to unscrew the door stop and
reinstall in the 90 degree position. Close the grill.
WARNING
Door Trim Pinch Point Hazard
Improper installation can lead to a finger pinch
point hazard between the side door trim and the
cabinets when operating the door, especiall
with children. To minimize this risk ou must
follow the installation instructions for cabinet
dimensions, trim assembl , and door stop angle.

STEP 8 INSTALL GRILLE PANEL

• Raise the access panel to the stop position.
Pin Location
as Shipped
for 115°
Door Swing
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
35