Side Panels; Side Cleats; Zug2 Grille Panel Dimensions; Unified Door Panel Dimensions - Monogram ZIFS360NHRH Installation Instructions Manual

SIDE PANELS

Side panels must be
used whenever the
sides of the unit will
be exposed. The 1/4"
side panels will slip
into the side case trim.
Secure the panels to
the unit with stick-on
hook and loop fastener
strips. Order the side
panels from the cabinet
manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
* Depending on
installation height.

SIDE CLEATS

Wood cleats are required to be installed vertically
down both sides of the cabinet opening to provide
depth stop for the refrigerator when installed into the
opening.
The cleat should be installed per the diagrams below
based on the type of panel being used.
TOP VIEW
Finished
Cleat
5-1/4"
3/4" Panel
Case Trim
TOP VIEW
Finished
Cleat
5-3/8"
1/2" Panel
Case Trim
Design Guide - Flush Installation
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"
DOOR
1/2"
DOOR
1/2"

ZUG2 GRILLE PANEL DIMENSIONS

The ZUG2 unified grille panel kit provides for the
installation of a framed or overlay grille panel.
Note: For 3/4" panels , use the same routing
instructions as single installation , page 28.
Framed Panel Dimensions
3/4" Routed Panel
Overlay Panel Dimensions
1/4" Backer Panel
0.10" Spacer Panel
1/2" Smooth Panel
IMPORTANT NOTE: The maximum weight for the
unified grill is 25 pounds.
Assemble the overlay panels in the same manner
as the door panel.

UNIFIED DOOR PANEL DIMENSIONS

Door panel dimensions for dual installation will be
69-3/4" x 36-7/8". For 3/4" panels follow the same
routing procedure per instrucitons on page 27.

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often enough
to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
29
A (Width) B (Height)
74" 10-7/16"
A (Width) B (Height)
69-7/8" 8-7/8"
68-1/2" 7-5/8"
74" 10-7/16"