Step 6 Level Unit - Monogram ZIFS360NHRH Installation Instructions Manual

36” built-in all-refrigerators and all-freezers
Hide thumbs Also See for ZIFS360NHRH:
Table of Contents

Advertisement

Installation Instructions - Flush Installation
STEP 5 INSTALL ANTI-TIP BRACKET (cont.)
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out to
remove.
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out to
remove.

STEP 6 LEVEL UNIT

All models have 4-point leveling. The front is supported by
leveling legs; the rear is supported by adjustable wheels.
Both are accessible from the front of the unit.
• To level the back of the unit, turn the 7/16" hex nut
located above the front wheels. Turn clockwise to raise or
counterclockwise to lower the unit.
• For front leveling, use a 1-1/4" open-end wrench.
• Adjust height of unit to match installation cutout
opening 84-1/2". The unit should be level and plumb with
cabinetry.
NOTE: Raise
appliance
until the case
top comes in
contact with
the 1" spacer
block mounted
to the underside
of the cabinet
soffit. Appliance
should be level
at fully raised
position.
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so now.
Move Unit into Final Position
• Move appliance toward its final installed location. Align
the tabs on the wall bracket with the openings in the back
of the unit.
• The unit has "L" bolts in the upper left and right corners
inside of the access compartment. These bolts will
interlock with the wall bracket and secure the unit using
the washers and hair pin cotters in the hardware kit once
the unit has been leveled and is in the final position.
CAUTION
The rear leveling wheels and front leveling legs are limited
to a maximum height adjustment of 1". If the installation
requires more than 84-1/2" height, the installer should
elevate the unit on a sheet of plywood or runners. Cabinetry
trim could also be added across the top of the opening to
shorten the opening. If you attempt to raise the unit more
than 1", you will damage the front leveling legs and the rear
leveling wheels.
ATTENTION
Les roues de nivellement arrière et les pattes de nivellement
avant permettent un réglage maximal de 25 mm (1 po).
Si l'ouverture pour l'appareil ménager a une hauteur
supérieure à 2,15 m (84-1/2 po), l'installateur doit élever
l'appareil ménager sur une feuille de contre-plaqué ou des
glissières. Il est également possible d'ajouter des baguettes
de finition des placards sur le haut de l'ouverture afin de la
réduire. Lever l'appareil ménager de plus de 25 mm (1 po)
endommage les pattes de nivellement avant et les roues de
nivellement arrière.
34

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zifs360nhlh

Table of Contents