Battery Instruction & Maintenance - Heartway Medical Products EV Rider Vita XPress S12E User Manual

BATTERY INSTRUCTION & MAINTENANCE
Safety Precautions for Lead Acid Batteries
Danger!! Failure to follow these precautions may result in serious risk.

Read through the charger operating instruction before using it.

If you use your scooter every day, please charge its batteries as soon as you finish using it for the day. Your scooter will be ready
each morning.
 Avoid deeply discharging your scooter's batteries.

Charge the battery at least 24 hours a week if the power chair or scooter has not been used.
(This is to make sure that the electrolyte is always at the top level)

If the battery cannot be charged (Orange light cannot turn to Green) or if the Orange light turns to Green immediately, please check
it with the technicians. The battery may be defective.

The voltage difference between the two batteries on a power unit cannot be more than 0.5 V; the battery case should be inspected
for cleanliness and evidence of damage.

If the charger indicates red light, please kindly check if the charger is defected or if the cable wiring connection is poor.
Please keep the battery and ⊕connectors clean otherwise the charging condition will be poor.


When installing batteries, please do not use sealed containers. Use of sealed containers may cause explosions, fires, injury, or
equipment damage.

Do not place batteries in enclosed environments or near open flames. Batteries may produce hydrogen which can cause explosions
or fires.

Do not use metal wires to connect batteries and prevent tools from making short circuit between batteries terminals. This can cause
fire or cause the battery to leak acid, overheat, or explode.

Do not transport or store batteries together with tools or metal wire. This can cause fire or cause the battery to leak acid, overheat,
or explode.

Charge batteries using specified chargers or as directed by the manufacturer. Charging batteries by any other methods can lead to
overheating, excessive hydrogen leaks, acid leaks, or explosions.

Pliers, torque wrenches and other metal tools should be insulated with PVC tape before use. Failure to do so could cause short
circuits which could lead to sparking or high temperature which could cause fire, damage or explosions of the battery.