Table of Contents
Advertisement
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power cord, for wear or damage.
Have your authorized dealer repair or replace any damaged connector, connection, or insulation that you find before using your
scooter again.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all pre-lubricated, sealed, and require no subsequent lubrication.
WHEEL REPLACEMENT
If your scooter is equipped with pneumatic tires and you have a flat tire, you can have the tube replaced. If your scooter is equipped
with a solid tire insert either the solid insert or the entire wheel must be replaced depending on the model. Contact your authorized
dealer regarding replacement wheels for your scooters.
WARNING
Wheels on your scooter should only be serviced/replaced by a qualified technician.
Completely deflate pneumatic tires before dismantling the rim or attempting repair.
Be sure that the key is removed from the key switch and the scooter is not in free-wheel mode before performing this procedure
repair.
When changing a pneumatic tire, remove only the lug nuts, then remove the wheel. If any further disassembly is required, deflate
the tire completely or it may explode.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodically for wear by your
authorized dealer.
CONSOLE, CHARGER, AND REAR ELECTRONICS
Keep these areas free of moisture.
Allow these areas to dry thoroughly if they have been exposed to moisture before operating your scooter again.
Advertisement
Table of Contents
