Storing Your Scooter - Heartway Medical Products EV Rider Vita XPress S12E User Manual

STORING YOUR SCOOTER

If you plan on not using your scooter for an extended period of time, it is best to:

Fully charge its batteries prior to storage.

Disconnect the batteries from the scooter.

Store your scooter in a warm, dry environment.

Avoid storing your scooter where it will be exposed to temperature extremes.
Batteries that are regularly and deeply discharged, infrequently charged, stored in extreme temperatures, or stored without a full
charge may be permanently damaged, causing unreliable performance and limited service life. It is recommended that you charge
the scooter batteries periodically throughout periods of prolonged storage to ensure proper performance.
Disposal of Your Power Scooter
Your power scooter must be disposed of according to applicable local and national statutory regulations. Contact your local waste
disposal agency or authorized dealer for information on proper disposal of power scooter packaging, metal frame components,
plastic components, electronics, batteries, neoprene, silicone, and polyurethane materials.
CHECKS:

Make sure to keep the controller clean while protecting it from rain or water. Never hose off your power scooter or place it in direct contact
with water.

Keep wheels free from lint, hair, sand and carpet fibers.
 Visually inspect the tire tread. If less than 1mm (1/32"), please have your tires replaced by your local dealer.

All upholstery can be washed with warm water and mild soap. Occasionally check the seat and back for sagging, cuts and tears. Replace if
necessary. Do not store your scooter in damp or humid conditions as this will lead to mildew and rapid deterioration of the upholstery parts.

All moving mechanism will benefit from simple lubrication and inspection. Lubricate using petroleum jelly or light oil. Do not use too much
oil, otherwise small drips could stain and damage carpets and furnishings etc. Always perform a general inspection of the tightness of all nuts
and bolts.
Cleaning and Disinfection

Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your power scooter. Avoid using products that
may scratch the surface of your power scooter.

If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on your product before
application. Follow all safety instructions for the proper use of the disinfectant and/or cleaning agent before applying it to your product.
Failure to comply may result in skin irritation or premature deterioration of upholstery and/or power scooter finishes.