Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
ArtNo.0102-0011 - Screwing
Fig. 9.3
the control valve bypass screw
Centre burner
Large burner
Right front burner
Fig. 9.4
Type 1
ArtNo.102-0005 - Gas regulator types
Fig. 9.5
ArtNo.103-0006 - Maxitrol cap & converter
Fig. 9.6
ArtNo.102-0007 - Maxitrol converter device positions
Natural Gas & Propane Gas
49
38
31
Table 9.2
Type 2
Nut
Snap-in converter device
CONVERSION
Valve Adjustment
Disconnect from the electricity supply.
Pull off all the control knobs.
Open the oven door and remove the 3 fixing screws
underneath the control panel (Fig. 9.2).
Remove 3 screws from the upper rear of the control panel
Pull the bottom of the control panel forward and lift clear.
Remove the electrical connections from the rear. Taking care
not to damage the control panel, and protecting it with cloth
for example, rest it on the open oven door.
Turn the bypass screw on each control clockwise to the stop
(Fig. 9.3). Connect the electrical connectors to the rear of the
control panel and locate it over the front lip of the hob. Fit the
6 fixing screws and control knobs.
See Table 9.2 for screw sizes.
Gas Regulator
To access the gas regulator remove the storage drawer.
Pull the drawer right out. Unscrew the two fasteners either
side of the drawer. Remove the screws and washers. Lift
the drawer off the drawer runners. The regulator is now
accessible.
For safety reasons slide the drawer runners back into the
cavity.
The regulator may be one of two types (Fig. 9.4).
Type 1
Unscrew the hexagonal nut in the front of the regulator. The
regulator nut has a plastic snap in converter device on the
underside (Fig. 9.5). To convert the regulator, snap the device
out of the nut and refit the other way up.
The snap in converter device is marked to show which gas it
is set for (Fig. 9.6). Make sure the device is secure in the base
of the nut and refit the nut to the regulator.
40
Advertisement
Table of Contents
