Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
the range, the area that the range will rest on should be built
up with plywood to the same level or higher than the floor
covering.
This will allow the range to be moved for cleaning or
servicing. Also, make sure your floor covering will withstand
180 °F (80 °C); see the 'Installation Safety Instructions' section.
Make sure the wall coverings around your range can
withstand the heat generated, up to 200 °F (90 °C), by the
range; see the 'Installation Safety Instructions' section.
You will also need the following tools:
1.
Electric drill
2.
Masonry drill bit & anchors (only required if installing
the range on a stone or concrete floor)
3.
Steel tape measure
4.
Phillips head screwdriver
5.
Flat head screwdriver
6.
2.5 mm Allen key (supplied with the range)
7.
Spirit level
8.
Open-end or adjustable wrench
9.
Pencil and ruler
10. Pipe wrenches
Additional materials you may need:
• Gas line shut-off valve.
• Pipe joint sealant or UL-approved pipe thread tape with
Teflon* that resists action of natural and LP gases.
• Flexible metal appliance connector (½'' I.D.). A 5 foot
length is recommended for ease of installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
• Flare union adapter for connection to gas supply line
(¾'' or ½'' NPT x ½'' I.D.).
• Flare union adapter for connection to pressure regulator
on range (½'' NPT x ½'' I.D.).
• To protect any floor covering under the range a sheet of
¼'' thick plywood or equivalent large enough to stand
the range on.
*Teflon: Registered trademark of DuPont
INSTALLATION
Checking the parts:
6 grates
ArtNo280-0084 DF Pan Supports
1 broiler rack with telescopic
runners
2 broiler pans with grids
ArtNo.331-0008 - 90SC
grill pan & trivet
Griddle (Optional Extra)
2 sets of side supports
2 side panel extensions
ArtNo.351-0001 - Side extension
panel USA
Conversion kit from natural gas to
propane gas
ArtNo.020-0019
Conversion Kit USA
26
2 flat racks with telescopic runners
ArtNo.326-0014 - Cradle rack (Falcon)
Control knob (°C)
Wok cradle (Optional Extra)
ArtNo.350-0007 - Plinth USA
Reducer plates for conduit
ArtNo.020-0012 Reducer Plates USA
Allen key
Toe kick
connection
Anti-tip device
Advertisement
Table of Contents
