Accessories - AGA Professional AMPRO36DF-SS User Manual

Accessories

Oven Racks
Each range is supplied with the following:
• 1 broiler pan rack with telescopic runners (Fig. 2.24)
• 2 flat racks with telescopic runners (Fig. 2.25)
• 2 broiler pans with grids (Fig. 2.26)
• 2 sets of ladder rack supports (Fig. 2.27)
The oven shelves are retained when pulled forward but can
be easily removed and refitted.
Shelves
To Fit the Telescopic Shelf Runners
Please note that it is not possible to fit telescopic runners to
the bottom rack support location (Fig. 2.28)
With the runner arm in the closed position locate the opening
of the upper rear slot onto the side support (Fig. 2.29).
Do not locate any further than the opening at this point.
Although not shown in Fig. 2.29, fitting is the same for the
upper stud type supports.
Lift the front of the runner arm to locate the front slot against
the side support (Fig. 2.29).
Push the runner arm towards the rear of the oven. The catch
at the front will lift and drop to secure the runner arm in place
(Fig. 2.29).
To Fit a Shelf to the Telescopic Shelf Runners
Slide the telescopic runners forward until they stop. Holding
the shelf above the runners, tilt the front downward and
locate into the front of the runners. Lay the shelf flat. Press on
the rear of the shelf to secure in place.
To Remove a Shelf from the Telescopic Shelf Runners
Slide the shelf out on the runners. While holding one of the
runners securely, carefully lift the rear of the shelf upwards:
the shelf will spring clear of the central restraining tab. Repeat
for the opposite side of the shelf.
Note: To aid the removal of the shelf you can insert a suitable
flat tool through the opening in the side of the runners and
lever the shelf clear (Fig. 2.30).
Tilt the front of the shelf downwards and then lift clear of the
runners (Fig. 2.31).
To Remove the Telescopic Shelf Runners
Firstly, remove the shelf as in the 'To Remove a Shelf from the
Telescopic Shelf Runners' section.
Place a finger on the underside of the telescopic runner and
lift.
Open the catch on top of the runner and pull the runner
forward and down to remove.
Fig. 2.24
ArtNo.326-0014 - Cradle rack (Falcon)
Fig. 2.26
ArtNo.331-0008 - 90SC
grill pan & trivet
2
3
Fig. 2.30
11
Fig. 2.25
Fig. 2.27
Fig. 2.28
Fig. 2.29
1
Fig. 2.31