Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Fig. 8.10
Stability bracket
Anti-tip bracket
1/8" (3 mm) min
ArtNo.070-0014 - Stability bracket - Wall fitting
Fig. 8.11
Outer stability
Outer anti-tip
bracket
bracket
1/8" (3 mm) min
Wall
Typical wall mounting
Fig. 8.12
Fig. 8.13
Cooker
Range
3 mm min
Typical oor mounting
Range
Cooker
3 mm min
INSTALLATION
Floor Fixing
Using the screw supplied, assemble the anti-tip bracket base
and anti-tip bracket extension (Fig. 8.9).
Using suitable screws and fixings, attach the assembled anti-
tip bracket to the floor to give a sufficient engagement into
the back of the range.
Adjust and lock the inner anti-tip bracket to give a 1/8" (3 mm)
clearance above the engagement edge in the back of the
Floor
range (Fig. 8.10).
Wall Fixing
Where floor fixing is impractical and provided that the outer
anti-tip bracket can be attached to a solid wall, the anti-tip
device may be attached to a wall (Fig. 8.11). Make sure to use
suitable screws and fixings.
Side Panel Extension kit
Two side extension panels are supplied with the range. These
can be installed where the side of the range is exposed,
Floor
preferably during the installation of the appliance.
Procedure
1.
Loosen the 2 screws in the rear edge of the range side
panel.
2.
Using the cut-outs, locate the side extension onto the
protruding screw heads (Fig. 8.12).
3.
Push the side extension up to so that the tab in the
bottom of the flue extension fits into the slot at the top
(Fig. 8.13).
4.
Hold the side extension in place and tighten the screws
to secure.
30
Advertisement
Table of Contents
