Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have nished.
Adjust and lock the inner anti-tip bracket to give a
clearance above the engagement edge in the back of the
range (Fig.7-11).
Wall Fixing
Where oor xing is impractical and provided that the outer
anti-tip bracket can be attached to a solid wall, the anti-tip
device may be attached to a wall (Fig.7-12). Make sure to use
suitable screws and xings.
Side Panel Extension kit
Two side extension panels are supplied with the range. These
can be installed where the side of the range is exposed,
preferably during the installation of the appliance.
Procedure
1.
Loosen the 2 screws in the rear edge of the range side
panel.
2.
Using the cut-outs, locate the side extension onto the
protruding screw heads (Fig.7-13).
3.
Push the side extension up to so that the tab in the
bottom of the ue extension ts into the slot at the top
(Fig.7-14).
4.
Hold the side extension in place and tighten the screws
to secure.
INSTALLATION
/
" (3 mm)
1
8
29
Anti-tip bracket
Stability bracket
3 mm min
1/8" (3 mm) min
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
Outer stability
Outer anti-tip
bracket
bracket
3 mm min
1/8" (3 mm) min
Wall
Typical wall mounting
Fig.7-11
Cooker
Range
Floor
Fig.7-12
Cooker
Range
Floor
Fig.7-13
Fig.7-14
Advertisement
Table of Contents
