Starting And Stopping The Nwa1123 - ZyXEL Communications NWA1123 Series User Manual

The following are the LED descriptions for your NWA1123.
Table 4 NWA1123-AC HD LED
COLOR
Amber
Green
Green
Bright Blue
Red
Red
Red
Green
Blue

2.6 Starting and Stopping the NWA1123

Here are some of the ways to start and stop the NWA1123.
Always use Maintenance > Shutdown or the shutdown command
before you turn off the NWA1123 or remove the power. Not doing so can
cause the firmware to become corrupt.
Table 5 Starting and Stopping the NWA1123
METHOD
Turning on the power
Rebooting the
NWA1123
Using the RESET button
Clicking Maintenance
> Shutdown >
Shutdown or using the
shutdown command
Disconnecting the
power
The NWA1123 does not stop or start the system processes when you apply configuration files or run shell
scripts although you may temporarily lose access to network resources.
Chapter 2 Standalone AP Mode
STATUS DESCRIPTION
Slow Blinking (On for 1s, The NWA1123 is booting up.
Off for 1s)
On
On The NWA1123 is ready for use, the NWA1123's wireless interface is
activated, and/or wireless clients are connected to the NWA1123.
On The NWA1123's wireless interface is activated, but there are no wireless
clients connected.
On The NWA1123 failed to boot up or is experience system failure.
Fast Blinking (On for The NWA1123 is undergoing firmware upgrade.
50ms, Off for 50ms)
Slow Blinking (blink for 3 The Uplink port is disconnected.
times, Off for 3s)
Slow Blinking (blink for 1 The wireless LAN is disabled or fails.
time, Off for 1s)
Slow Blinking (blink for 1 The NWA1123 is checking for an available 5GHz channel.
time, Off for 1s)
DESCRIPTION
A cold start occurs when you turn on the power to the NWA1123. The NWA1123 powers
up, checks the hardware, and starts the system processes.
A warm start (without powering down and powering up again) occurs when you use the
Reboot button in the Reboot screen or when you use the reboot command. The
NWA1123 writes all cached data to the local storage, stops the system processes, and
then does a warm start.
If you press the RESET button on the back of the NWA1123, the NWA1123 sets the
configuration to its default values and then reboots. See
more information.
Clicking Maintenance > Shutdown > Shutdown or using the shutdown command writes all
cached data to the local storage and stops the system processes. Wait for the device to
shut down and then manually turn off or remove the power. It does not turn off the
power.
Power off occurs when you turn off the power to the NWA1123. The NWA1123 simply turns
off. It does not stop the system processes or write cached data to local storage.
NWA1123 Series User's Guide
25
Section 25.6 on page 205 for