Standalone Configuration; Overview; Starting And Stopping The Zyxel Device - ZyXEL Communications NWA90AX User Manual

Standalone Configuration

5.1 Overview

The Zyxel Device is in standalone mode by default. Use the web configurator to manage and configure
the Zyxel Device directly. As shown in the following figure, WiFi clients can connect to the Zyxel Device
(A) to access network resources.

5.2 Starting and Stopping the Zyxel Device

Here are some of the ways to start and stop the Zyxel Device.
Always use Maintenance > Shutdown or the shutdown command
before you turn off the Zyxel Device or remove the power. Not doing so
can cause the firmware to become corrupt.
Table 13 Starting and Stopping the Zyxel Device
METHOD
Turning on the power
Rebooting the Zyxel
Device
DESCRIPTION
A cold start occurs when you turn on the power to the Zyxel Device. The Zyxel Device
powers up, checks the hardware, and starts the system processes.
A warm start (without powering down and powering up again) occurs when you use the
Reboot button in the Reboot screen or when you use the reboot command. The Zyxel
Device writes all cached data to the local storage, stops the system processes, and then
does a warm start.
NWA50AX/NWA90AX/NWA55AXE Series User's Guide
C
H A P T E R
43
5