Locator Screen - ZyXEL Communications NWA1123 Series User Manual

The following table describes fields in the above screen.
Table 77 Maintenance > LED > Suppression
LABEL
Suppression On
Apply
Reset

17.3 Locator Screen

The Locator feature identifies the location of your NWA1123 among several devices in the network. You
can run this feature and set a timer in this screen.
To run the locator feature, enter a number of minutes and click Turn On button to have the NWA1123
find its location. The Locator LED will start to blink for the number of minutes set in the Locator screen. The
default setting is 10 minutes. While the locator is running, the Turn On button will gray out and return
after it's finished. If you make changes to the time default setting, it will be stored as the default when
the NWA1123 restarts.
Note: The Locator feature is not affected by the Suppression setting.
To access this screen, click Maintenance > LEDs > Locator.
Figure 111 Maintenance > LEDs > Locator
The following table describes fields in the above screen.
Table 78 Maintenance > LED > Locator
LABEL
Turn On
Turn Off
Automatically Extinguish
After
Apply
Refresh
Chapter 17 LEDs
DESCRIPTION
If the Suppression On check box is checked, the LEDs of your NWA1123 will turn off after it's
ready.
If the check box is unchecked, the LEDs will stay lit after the NWA1123 is ready.
Click Apply to save your changes back to the NWA1123.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Click Turn On button to activate the locator. The Locator function will show the actual
location of the NWA1123 between several devices in the network.
Otherwise, click Turn Off to disable the locator feature.
Enter a time interval between 1 and 60 minutes to stop the locator LED from blinking.
Default is 10 minutes.
Click Apply to save changes in this screen.
Click Refresh to update the information in this screen.
NWA1123 Series User's Guide
176