Locator Screen - ZyXEL Communications HD User Manual

The following table describes fields in the above screen.
Table 85 Maintenance > LED > Suppression
LABEL
Suppression On
Apply
Reset

18.3 Locator Screen

The Locator feature identifies the location of your NWA/WAC among several devices in the network.
You can run this feature and set a timer in this screen.
To run the locator feature, enter a number of minutes and click Turn On button to have the NWA/WAC
find its location. The Locator LED will start to blink for the number of minutes set in the Locator screen. The
default setting is 10 minutes. While the locator is running, the turn on button will gray out and return after
it's finished. If you make changes to the time default setting, it will be stored as the default when the
NWA/WAC restarts.
Note: The Locator feature is not affected by the Suppression setting.
To access this screen, click Maintenance > LEDs > Locator.
Figure 122 Maintenance > LEDs > Locator
The following table describes fields in the above screen.
Table 86 Maintenance > LED > Locator
LABEL
Turn On
Turn Off
Automatically Extinguish
After
Apply
Refresh
Chapter 18 LEDs
DESCRIPTION
If the Suppression On check box is checked, the LEDs of your NWA/WAC will turn off after it's
ready.
If the check box is unchecked, the LEDs will stay lit after the NWA/WAC is ready.
Click Apply to save your changes back to the NWA/WAC.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Click Turn On button to activate the locator. The Locator function will show the actual
location of the NWA/WAC between several devices in the network.
Otherwise, click Turn Off to disable the locator feature.
Enter a time interval between 1 and 60 minutes to stop the locator LED from blinking.
Default is 10 minutes.
Click Apply to save changes in this screen.
Click Refresh to update the information in this screen.
NWA / WAC Series User's Guide
194