Target Data; Basic Target Data - Furuno FAR-2807 Operator's Manual

4.7

Target Data

You may display an AIS target's data by selecting it on the display, when the AIS
function is set for "AIS DISP FILT".
4.7.1

Basic target data

By keyboard
1. Use the trackball to put the cursor on the AIS target symbol you want to know
its data.
2. Press the [TARGET DATA] key.
By trackball
1. With the cursor inside the effective display area, roll the scrollwheel to
display "TARGET DATA & ACQ / CURSOR MENU".
2. Use the trackball to put the cursor on an AIS target symbol. The selected
target is marked with a broken square and AIS data is shown in the AIS data
box when the target is correctly selected.
Location of target data, MMSI No.
Name of ship
Bearing to target
Range to target
Target's course
Target's speed
Target's CPA
Target's TCPA
Target's bow cross range
Target's bow cross time
A
Location of target's data box.
Not shown on W-type radar.
Activated target selected for data display
AIS B MMSI 665498114
VOYAGER
BRG 208.6 T
RNG 12.3NM
TCOG 9.0 T *1
TSOG 8.2kn#
CPA 5.32NM
TCPA 33:31
BCR 5.65NM
BCT 25:30
*1 = CTW (course) when water tracking mode is selected at radar.
*2 = STW (speed thru water) when tracking mode is selected at radar.
*3 = In the case of Class B, Nav status is replaced with "CLASS B"
*4 = In the case of Class B, Rate of turn is not displayed
AIS data display
34 37.912 N
135 21.569 E
NAV-STATUS
UNDER WAY
USING ENGINE
*2
HDG 048.0 T
0.0 /min
4. AIS OPERATION
Position
*3
Nav status
Heading
*4
Rate of turn
4-11