Radar Map Corrections; Radar Map Correction; Cursor Data Correction - Furuno FAR-2807 Operator's Manual

5. VIDEO PLOTTER OPERATION
5.6

Radar Map Corrections

5.6.1

Radar map correction

When there is positional error between the radar screen and radar map marks
and lines, do the following to correct it.
1. With the cursor inside the effective display area, roll the scrollwheel to
display "CHART ALIGN L=OFF / EXIT" in the guidance box.
2. Operate the trackball to align the radar map with the radar screen.
3. Push the left button to set. "CHART ALIGN" appears at the right side of the
screen.
To release the radar map correction, display "CHART ALIGN L=OFF / EXIT"
in the guidance box then push the left button until "CHART ALIGN" disappears
from the screen.
5.6.2

Cursor data correction

You can correct cursor data as below.
1. Left-click the MENU box to open the menu.
2. Select 5 [PLOTTER] to open the PLOTTER menu.
1 BACK
2 CHART COLOR*
3 OWN TRACK INTERVAL
4 OWN TRACK COLOR*
5 TGT TRACK INTERVAL*
6 TGT TRACK COLOR*
7 CURSOR L/L ALIGN
8 [DATA ERASE]
9 [DISPLAY]
0 AUTO TARGET TRACK*
3. Select 7 CURSOR L/L ALIGN.
5-8
[PLOTTER]
GRN/YEL/CYA
ORANGE/GRAY
OFF/DRAW/10S/30S/
1M/2M/3M/6M/15M
RED/GRN/BLU/YEL/
CYA/MAG/WHT
OFF/DRAW/10S/30S/
1M/2M/3M/6M/15M
RED/GRN/BLU/YEL/
CYA/MAG/WHT
OFF/ON
OFF/ON
* Not available on IMO type
PLOTTER menu