User Settings - Furuno FAR-2807 Operator's Manual

1. RADAR OPERATION
9. Push the right button four times to close the menu.
10. Use the EBL offset feature to anchor the net cursor at net origin point.
a) Push the EBL OFFSET key.
b) Use the trackball to set net origin point.
c) Push the EBL OFFSET key to anchor the net cursor.
11. Steer the vessel so your ship's trail runs along the net cursor then throw the
net.
1.56

User Settings

The function settings shown in the table below can be reset to their default
setting by enabling PILOT SETTING. (Functions not shown below maintain their
previous setting.)
The unit also has the ability to store 2 separate sets for the settings below in its
internal memory. You are also able to recall these settings. (Items not shown
below cannot be stored or recalled.)
Function
Tuning
Range
Range Rings
VRM1 Display
Distance
VRM2 Display
Distance
EBL1 Display
Bearing
Reference
EBL2 Display
Bearing
Reference
PI Lines Display
Interval
Orientation
Bearing (True or
REL)
Numbers(1, 2, 3 or 6)
Mode (Parallel or
Perpendicular)
Presentation Mode
Stabilization Mode (Sea or Ground)
1-110
Settings
Maintained as per the
previous setting.
6 NM
OFF
ON
0.25 NM
OFF
0.000 NM
ON
0.0 degrees
TRUE
OFF
0.0 degrees
TRUE
Maintained as per the
previous setting.
NORTH UP TM
GPS (Ground stabilization)
(Continued on next page)
Remarks
TUNE Box
RANGE Box
[MENU] > 2 [MARK] > 0 [RING]
VRM1 Box
VRM2 Box
EBL1 Box
[MENU] > 2 [MARK] > 9 [EBL
CURSOR BEARING] *1
EBL2 Box
[MENU] > 2 [MARK] > 9 [EBL
CURSOR BEARING] *2
PI LINE Box
[MENU] > 2 [MARK] > 4 [PI LINE] >
2 [PI LINE BEARING]
*3
[MENU] > 2 [MARK] > 4 [PI LINE] >
3 [PI LINE]
[MENU] > 2 [MARK] > 4 [PI LINE] >
4 [PI LINE MODE]
PRESENTATION MODE Box
[SPEED MENU] > 1 [SHIP SPEED]