Selecting An Antenna; Cursor Data - Furuno FAR-2807 Operator's Manual

1.45.3

Selecting an antenna

For the ship that carries multiple antennas, you may choose the antenna to use
as follows:
1. Roll the trackball to place the arrow in the ANTENNA box at the left side of
the screen.
2. Roll the scrollwheel to choose an antenna then push the left button.
1.46

Cursor Data

Cursor data can be shown in latitude and longitude
position or cursor's X-Y coordinates, with the C
specification radar.
Left-click the CURSOR DATA box at the right side of the
display to select the cursor data to show. The cursor data
changes in the sequence shown below.
Note 1: For the X-Y coordinates display, the Y-axis is the heading line, right/top
is "plus" and left/lower is "minus."
Note 2: When displaying latitude and longitude position and the cursor has been
aligned (on the PLOTTER menu), the indication "CHART ALIGN"
appears at the right side of the screen (in yellow).
Note 3: Cursor data reads "- - -.-" when the cursor is placed outside the effective
display area.
Note 4: Cursor bearing format (true or relative) and cursor range unit (nm, sm,
km or kyd) are available as below.
Type Cursor bearing
format
IMO Yes
A Yes
B Yes
C Yes
W Yes
ANT1 X-BAND (M)
34 30.323 N
+
135 08.263 E
9.649NM
+
9.683NM
Cursor data options
Cursor Menu operation
range unit
No 2 [MARK] 9 EBL CURSOR BEARING
No
Yes 2 [MARK]
BEARING, CURSOR RANGE
Yes
No
Latitude and longitude
position of cursor
Cursor X-Y position
9 [EBL, VRM CURSOR SET]
1. RADAR OPERATION
34 40.849 N
+
135 18.303 E
CURSOR DATA
box (L/L position)
CURSOR
1-95