F - Setting Up Tilt Door - B&D PanelMax SDO-8 Installation Instructions Manual

PanelMax installation instructions

F - Setting up Tilt Door

Prior to limit set up, the opener can be set to J-Type Tilt Profile. This process allows the opener to pre-set to J-Type
settings where the limit is not greater than 1500mm. If J-Type is selected, the speed is customised and cannot be
changed.
a. Press the MODE button repetitively until the GEAR
b. Press and hold STOP / SET button for 2 seconds to check the door type, until the main courtesy light turns solid
ON or OFF.
• Main courtesy light ON - Tilt type (J-Type only)
• Main courtesy light OFF - Sectional type
c. Press and hold STOP / SET for 6 seconds to change the door type, until the main courtesy light turns solid ON
or OFF. If required, repeat step b to check the door type selected.
d. Press MODE button to exit the door selection mode. Proceed to Section 12 to set the limits.
b&d doors office locations
Head Office 6-8 Fiveways Blvd, Keysborough 3073
New South Wales 34 Marigold St, Revesby 2212
Queensland
17 Oasis Court, Clontarf 4019
Victoria 147-153 Canterbury Rd, Kilsyth 3137
South Australia
23 Frederick Rd, Royal Park 5014
Western Australia 96 Mulgul Rd, Malaga 6090
International/Export
34 Marigold St, Revesby 2212
Prefixed trademarks are the property of B&D Australia Pty Ltd. B&D Doors & Openers
is a division of B&D Australia Pty Ltd. ABN 25 010 473 971. © 2018 B&D Australia Pty Ltd.
www.bnd.com.au
LED starts flashing.
Phone (03) 9791 2000
Phone (02) 9722 5555
Phone (07) 3883 0200
Phone (03) 9237 7766
Phone (08) 8440 4747
Phone (08) 9247 8777
Phone +61 (0)2 9722 5555
23
your representative is