Coding A Transmitter; Storing The Transmitter Code; Erasing All Transmitter Codes; Vacation Mode - B&D PanelMax SDO-8 Installation Instructions Manual

PanelMax installation instructions

15. Coding a Transmitter

15.1 Storing the Transmitter Code

The opener can only operated from remote control
transmitters that have been programmed into
its memory. Up to 64 codes can be stored in the
memory.
a. Press the MODE button repetitively until the
TRANSMIT LED is lit.
b. Press and HOLD the button/s indicated in the
table to set the required transmitter function. The
Main light will start to flash rapidly.
c. Press one of the four (4) buttons on the transmitter
until the main light starts to flash rapidly, then
release transmitter button.
d. Press the remote control button again until the
main light stops flashing rapidly.
e. Release both buttons. Press the MODE button to
exit. The transmitter button is now coded, press
to test.
NOTE: Refer to the Light indicator table for the
details of the transmitter status.
MAIN LIGHT TRANSMITTER STATUS
ON Button added
OFF Button removed
2 FLASHES, then OFF Remote control deleted
4 FLASHES, then OFF Memory full
15.2 Installation of
Transmitter
a. Store the transmitter code as per instructions
above. Test the transmitter button.
b. Mount the transmitter in a convenient location,
yet out of reach of children and at least 1.5m off
the ground.
c. Make sure the door is visible from this location.
the Wall Mounted
TRANSMITTER
FUNCTION
Open / Stop / Close
PET (Pedestrian) Mode
Open
Light

Vacation Mode

* The button coded for open only function can close the door if you
hold the button for 4 seconds, when the door is fully open..

15.3 Erasing All Transmitter Codes

a. Press the MODE button repetitively until the TRANSMIT
LED is lit.
b. Press and hold the MODE button for 10 secs, let the MODE
button go when the main light stops flashing.
c. Follow steps a - e in Storing the Transmitter Code to code
new transmitters.
15.4 Vacation Mode
a. To turn on Vacation mode and lock out all remotes, press
the button on the remote programmed with Vacation
Mode.
b. To turn off Vacation Mode, press the transmitter button
programmed to vacation mode to turn off.
BUTTON
HOLD
HOLD
HOLD HOLD
HOLD
12
HOLD
HOLD