G - Setting Up Tilt Door - B&D Smart Pro SDO-9V3 Installation Instructions Manual

Smart Pro, Smart & Secure installation instructions

G - Setting up Tilt Door

If installing on a door with a bad wave action,
tip
lengthening the arm will assist in reducing this
effect.
7d
7i
7c
7f
Prior to limit set up, the opener can be set to J-Type Tilt
Profile. This process allows the opener to pre-set to J-Type
settings where the limit is not greater than 1500mm.
In JTYPE Mode the drive speed is reduced
tip
and cannot be adjusted.
b&d doors office locations
Head Office 6-8 Fiveways Blvd, Keysborough 3073
New South Wales 34 Marigold St, Revesby 2212
Queensland
17 Oasis Court, Clontarf 4019
Victoria 147-153 Canterbury Rd, Kilsyth 3137
South Australia
23 Frederick Rd, Royal Park 5014
Western Australia 96 Mulgul Rd, Malaga 6090
International/Export
34 Marigold St, Revesby 2212
Prefixed trademarks are the property of B&D Australia Pty Ltd. B&D Doors & Openers
is a division of B&D Australia Pty Ltd. ABN 25 010 473 971. © 2018 B&D Australia Pty Ltd.
www.bnd.com.au
7f
2
7e
7j
7g
7b
7i
A
Switch power on
S T E P T W O
To activate JTYPE Mode
+
Press together and opener
will beep TWICE
OR
To move the door to the
halfway point.
Phone (03) 9791 2000
Phone (02) 9722 5555
Phone (07) 3883 0200
Phone (03) 9237 7766
Phone (08) 8440 4747
Phone (08) 9247 8777
Phone +61 (0)2 9722 5555
S E T T I N G U P T I L T D O O R
S T E P O N E
BLUE LED will ash
& gear LED lit
S T E P T H R E E
To return to Standard Mode
Press together and opener
will beep ONCE
S T E P F O U R
Proceed to Setting
Close Limit position.
your representative is
29
+
+