Table of Contents
Advertisement
PanelMax installation instructions
D - Setting Limits via Transmitter
a. Switch power on and the BLUE LED on the CLOSE button
will start to flash to indicate that the opener is ready
to set the Close travel limit
b. Press the MODE button repetitively until the TRANSMIT
LED is lit.
c. Press and HOLD the CLOSE button
/ Stop / Close function. The Main light will start to flash
rapidly.
d. Press and hold button 1 on the transmitter, then release
transmitter button.
e. Press and hold button 1 on the remote control button
again until the main light stops flashing rapidly.
f. Release both buttons. The transmitter button is now
coded, press to test and observe the speed of the door
through a full cycle.
g. The drive speed is set to the fastest setting by default.
This may not be suitable for larger doors or for single
piece doors:
CLOSE limit:
i. Using the programmed transmitter, press and hold
the button 4 to close. To inch the door, single presses
of the button 4 will move the door to desired limit.
ii. While inching (to CLOSE) to set the close speed, press
and hold button 4 on the remote and by pressing the
SET button 2 the opener will cycle through all three
speed modes as shown in table.
iii. Once at the desired speed, release the remote
button 4.
iv. Continue inching the door to the desired position.
We recommend the CLOSE limit position being
the first point of contact of the rubber strip ( at the
bottom of the door) with the ground.
v. If the door overshoots, press the OPEN button 1 on
the remote to move the door in the OPEN direction.
vi. When the door is at the desired CLOSE position, press
the SET button 2, the GREEN LED on the OPEN button
will now flash.
E - Setting the PET mode position
When activated, PET mode drives the door to a preset position from the
close position, therefore allowing a pet or parcel to go under the door.
a. Drive and stop the door at the desired PET mode open position by
pressing the transmitter button coded for Open/Stop/Close operation.
b. Press the MODE button repetitively until the GEAR
c. Press OPEN button
both OPEN and CLOSE LED will light up.
to set the Open
to save PET position - Main light will flash and
Button 1
(inch Open)
Button 4
(inch Close)
OPEN limit:
i. Using the programmed transmitter, press and
hold the button 1 to open. To inch the door, single
presses of the button 1 will move the door to
desired limit.
ii. While inching (to OPEN) to set the open speed,
press and hold button 1 on the remote and by
pressing the SET button 2 the opener will cycle
through all three speed modes as shown in table.
iii. Once at the desired speed, release the remote
button 1.
iv. Continue inching the door to the desired position.
We recommend the OPEN limit position being the
height of the garage opening
v. If the door overshoots, press the CLOSE button
4 on the remote to move the door in the CLOSE
direction.
WARNING! The door will automatically close,
open and close again after the next step.
Ensure that nothing is in the door's path.
vi. When the door is at the desired OPEN position,
press the SET button 2.
automatically close and open to calculate the
safety obstruction settings.
LED is lit.
22
Button 2
(Set)
The door will now
Hide quick links:
Advertisement
Table of Contents
