Mounting Brackets And Arms; Mounting The Door Bracket; Attaching The Arms; Connect To Power - B&D SDO-3V2 Controll-A-Door S Instruction Manual

8 Controll-A-Door S & PanelPro Instruction Manual
®

9. Mounting Brackets and Arms

Mounting The Door Bracket:

a. The door bracket locator
, on the door's centre line one-third down the top panel and
8
mounted using M6 or equivalent screws (not supplied),
b. STEEL DOORS ONLY: Bracket can be welded in place.
NOTE: If in doubt about the door's strength, reinforcement
may be added to the door's frame where necessary. Door
damage may occur if the bracket is installed on a panel
with insufficient strength. The opener's warranty does not
cover damage caused to the door and/or door panels.

Attaching the Arms

a. Assemble the bent arm
side of the straight arm
in the accessory pack. Connect the straight arm
shuttle with a clevis pin
b. Connect the assembled arm to the bracket with clevis pin

10. Connect to Power

Initial Preparation:
a. Move the door to the half way position.
b. Remove the clear button cover from the unit.
NOTE: This cover has a label that says "Do not remove" however, this
only applies during normal operation. This cover must be removed to
setup the opener.
c. Switch power on to the opener. The red CLOSE LIMIT LED will be
flashing.
d. Press and hold the MINUS (-) button - the door should start closing. If
door starts to close, release button.
NOTE: If the door opens, release the MINUS (-) button and press the
OPERATE button once to change the motor's direction.
is placed over the door bracket
7
7
8
(connecting to the door) to the right
4
with bolts and nuts
5 10
and a pin snap . Always use both bent and straight arms.
12 9
12
8
supplied
13
to the
5
and pin snap
12
9
6
13
4
A
7
9
. The angle "A" must be more than 10°.
9
12
5
10