Table of Contents
Advertisement
PanelMax installation instructions
10. Optional Safety Beam Kit
10.1 Safety Beams
The Safety Beam Kit provides additional safety by preventing the door closing
when the beam is blocked by a car, child etc. When the Safety Beam Kit is
installed the Auto-close feature can be enabled if required.
a. To install the Safety Beam Kit, refer to the Safety Beam instruction supplied
with the kit.
b. After the beams are installed the beam alignment feature of the opener
can be used.
c. Turn power on to the opener.
d. Align the safety beams using the main light as a guide:
i. bright = aligned
ii. dull = not aligned or blocked
When the beam is aligned or if no beam is fitted, continue with Setting Limits.
11. Specifications
Technical Specifications
Rated voltage range:
Rated frequency:
Rated power input:
Door opening:
Maximum Door Area:
Maximum Door Weight:
Door must be well balanced and able to be operated by
hand, as per warranty conditions and AS/NZS 4505:2012
Minimum headroom
Rated Operating Time
Rated Temp
Short Term Peak force:
Door travel speed (mm/sec)
Rated load
Nominal force
Receiver type
Receiver code storage capacity
Transmitter battery
Courtesy light
Network connectivity
* Gross door weight, including all fittings
Note: During the open and close cycles, intermittent operations may occur in areas which experience very strong
winds. The strong wind puts extra pressure on the door and tracks which may in turn intermittently trigger the safety
obstruction detection system.
PanelMax
TM
SDO-8
230V - 240Va.c.
50Hz / 60Hz
235W
15m
2
140kg*
57mm
4 mins
o
o
+5
C to +40
C
700N
180mm
400N
200N (20kg)
Multi-frequency UHF FM
64 X 4-button Transmitters
CR2032 (3 Volts)
LED (Light Emitting Diodes)
Network ready
(requires optional smart phone control kit)
8
Hide quick links:
Advertisement
Table of Contents
