Table of Contents
Advertisement
Expansion cards and riser modules
Removing the defective expansion card
▶ Remove the expansion card, see
page
132.
▶ If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see
Installing the new expansion card
▶ If applicable, install the slot bracket, see
page
118.
▶ Install the expansion card, see
Concluding steps
▶
"Installing the riser module" on page
▶
"Installing the CPU node" on page
▶
"Reassembling" on page
▶ If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for the MAC address of a LAN controller" on page
▶
"Updating the NIC configuration file in a Linux environment" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced expansion card.
Configuration of network settings should be performed by the
customer. For more information, see
recovery" on page
146
"Removing an expansion card" on
"Removing slot brackets" on page
"Installing an expansion card" on page
60.
50.
45.
48.
49.
145.
Upgrade and Maintenance Manual
"Installing slot brackets" on
"Note on network settings
121.
130.
76.
74.
GX2570 M6
Advertisement
Table of Contents
