Lubrication; Greasing Procedure; Lubrication Points - MacDon A30-S Operator's Manual

7.6 LUBRICATION

CAUTION
To avoid personal injury, before servicing
header/mower conditioner or opening drive
covers, follow procedures in Section 7.1
PREPARATION FOR SERVICING.
Refer to Section 7.3.2 Recommended Fluids
and Lubricants for recommended greases.
SAMPLE GREASE DECAL
The greasing points are marked on the machine
by decals showing a grease gun (A), and grease
interval (B) in hours of operation.
Log hours of
"Maintenance Checklist" provided to keep a
record of scheduled maintenance.
Section 7.18 MAINTENANCE SCHEDULE.
7.6.1

Greasing Procedure

a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose
immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
Form 169000 / 169040
SECTION 7 MAINTENANCE AND SERVICING
operation and use
Refer to
or broken fittings
7.6.2

Lubrication Points

Lubrication requirements depend on the model
of header/mower conditioner that is being
serviced.
Refer to the specified pages to identify
lubrication points for your specific model:
A30-S HEADER
A30-D HEADER
A40-D HEADER
HAY CONDITIONER
DRIVELINES
PULL-TYPE CARRIER Page 114
the
105
Pages 106 - 107
Pages 108 - 109
Pages 110 - 111
Page 112
Page 113
Revision D