Sealed Bearing Installation - MacDon A30-S Operator's Manual

7.6.4

Sealed Bearing Installation

a. Clean shaft, and coat with rust preventative.
C
B
b. Install flangette (A),
flangette (C), and lock collar (D).
The locking cam is only on one side of
the bearing.
c. Install (but do not tighten) flangette bolts (E).
d. When shaft is correctly located, lock the lock
collar with a punch.
The collar should be locked in the same
direction the shaft rotates. Tighten the
set screw in the collar.
e. Tighten flangette bolts (E).
f. Loosen flangette bolts on mating bearing one
turn, and re-tighten. This will allow the bearing to
line-up.
Form 169000 / 169040
SECTION 7 MAINTENANCE AND SERVICING
A
E
D
bearing (B), second
NOTE
NOTE
117
Revision D