Table of Contents
Advertisement
Set up, install, and configure
Notes:
•
View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the web page correctly.
2
Click Apps > Card Copy > Configure.
Notes:
•
Make sure that Display Icon is enabled.
•
Make sure that E‑mail Settings and Network Share Settings are configured.
•
When scanning a card, make sure that the scan resolution does not exceed 200 dpi for color and
400 dpi for black and white.
•
When scanning multiple cards, make sure that the scan resolution does not exceed 150 dpi for color
and 300 dpi for black and white.
3
Apply the changes.
Note: You need a printer hard disk or an intelligent storage drive to scan multiple cards.
Using Display Customization
Before using the application, make sure to do the following:
•
From the Embedded Web Server, click Apps > Display Customization > Configure.
•
Enable and configure the screen saver, slideshow, and wallpaper settings.
Managing screen saver and slide show images
1
From the Screen Saver and Slideshow Images section, add, edit, or delete an image.
Notes:
•
You can add up to 10 images.
•
When enabled, the status icons appear on the screen saver only when there are errors, warnings, or
cloud‑based notifications.
2
Apply the changes.
Changing the wallpaper image
1
From the home screen, touch Change Wallpaper.
2
Select an image to use.
3
Apply the changes.
Running a slide show from a flash drive
1
Insert a flash drive into the USB port.
2
From the home screen, touch Slideshow.
Images appear in alphabetical order.
Note: You can remove the flash drive after the slide show starts, but the images are not stored in the
printer. If the slide show stops, then insert the flash drive again to view the images.
34
Advertisement
Table of Contents
