Installation Location - Toshiba B-SX600 SERIES Owner's Manual

2.2 Installation Location

Install the printer in a place where ample space is reserved for operation. Also, place the printer on a
well ventilated, flat, level table or a rack specifically designed for the printer. Make sure that the 4 feet
of the printer make full contact with the surface of the desk or rack.
Ensure that there is sufficient space around the printer, as illustrated below.
%RH
5 °C 90%
80
18 °C
60
60%
5 °C
40
55%
18 °C
40%
20
10
Acceptable
operating
range
CAUTION
Precautions
･ Ensure that an AC outlet is located near the installation location of the printer and that it allows for the
easy plugging and unplugging of the Power Cord. Do not place any obstacles around the AC outlet.
･ When the Peel-off Unit is used, the backing paper is ejected continuously from the lower section of the
Peel-off Unit. Particularly, when a label in use is long, choose an installation location carefully in
order to prevent it from sticking on a table or the ejected backing paper.
28 °C
29 °C 90%
60%
2 8 °C
40 °C 39%
40%
40 °C 10%
20 30 40
Recommended
operating range
Avoid locations that have the following adverse conditions. Failure to
do this may cause injuries or printer failure.
･ Direct sunlight
･ High temperatures and humidity or low temperatures and humidity
･ Rapid temperature changes
･ Direct cold air
･ Excessive vibration
･ Dust/Gas
･ Near magnetic or electromagnetic devices
･ Near open flames or wet locations
･ On an unstable desk or rack
Left: 10 cm or over
°C
Front: 15 cm or over
2- 4
2. PRINTER SETUP
Back: 5 cm or over
Right: 30 cm or over