Toshiba B-SX600 SERIES Owner's Manual page 96

Error messages
Ribbon error
Reset ribbon.
Ribbon error
Reset head unit.
Peeling failed
Cut failed
Possible causes
The ribbon has torn apart.
The rotation of the ribbon
shaft has not been
detected.
Peeling has failed.
The media has not been cut
correctly.
12- 10
12. TROUBLESHOOTING
Solutions
• Reload a ribbon.
⇒
4. LOADING THE RIBBON
• If the ribbon has been heated by the Print
Head and torn apart, decrease the print
tone.
⇒
[Help] on the Printing Preferences
page in the Printer Driver Properties
Open the Side Cover. Place the Upper Unit
in a right position.
⇒
4. LOADING THE RIBBON
5.1 How to Load the Media
• If the loaded media is jammed in the Front
Cover section, clear it.
⇒
10.2 Removing Jammed Media from
the Peel-off Unit
• Replace the Rubber Roller in the Peel-off
Unit if it has worn out.
⇒
1.5.2 Precaution when using the
Peel-off Unit
• Select and use an appropriate size of the
media.
⇒
3. MEDIA AND RIBBON
• Check the printer driver settings.
⇒
[Help] on the Printing Preferences
page in the Printer Driver Properties
• The media size is specified correctly.
• The print area is specified correctly.
⇒
1.5.2 Precaution when using the
Peel-off Unit
• Remove jammed media from the way of the
Cutter Carriage.
⇒
10.1 Removing Jammed Media from
the Cutter Unit
• Select and use an appropriate size of the
media.
⇒
3. MEDIA AND RIBBON
• Check the printer driver settings.
⇒
[Help] on the Printing Preferences
page in the Printer Driver Properties
• The media size is specified correctly.
⇒
1.4.2 Precautions when using the
Cutter Unit
• The cutting edge of the Cutter is not sharp.
⇒
1.4.2 Precautions when using the
Cutter Unit