Media And Ribbon; Supply Specifications - Toshiba B-SX600 SERIES Owner's Manual

3. MEDIA AND RIBBON

3.1 Supply Specifications

Item
Media width (Backing
paper width)
Media thickness (total)
Media pitch
Label length
Label width
Label thickness
Backing paper
thickness
Material of backing
paper
Media type (Roll
direction)
Max. outside roll
diameter
Inner core diameter
Ribbon width
Ribbon roll direction
Ribbon inner core
diameter
End of ribbon
Outside roll diameter
∗
1 If the length of a label is long, place the printer on a surface where an ejected label does not
stick to the printer or floor.
∗
2 Feed fanfold paper from back of the printer.
(→ 5.3 How to Load Fanfold Paper)
∗
3 Use a ribbon that is at least 10 mm wider than the media.
Supplemental Remarks
･ In the case of peel-off operation, use of perforated labels is not allowed.
･ Feed fanfold paper through the Fanfold Paper Slot on the printer back.
Batch/Tear-off mode
5 mm to 1,000 mm
-
-
-
-
-
Roll (Inside/outside)
∗2
Fanfold
∅200 mm
∅76.2 mm
30 to 120 mm (A ribbon must be at least 10 mm wider than the loaded
media.)
Ink side faces outside
∅25.4 mm to ∅ 26.4 mm
Minimum of 200 mm long silver film is attached to the end of the ribbon.
∅70 mm or less (Ribbon length: Approx. 300 m or less)
3- 1
Strip mode
15 mm to 120 mm
0.08 mm to 0.26 mm
12 mm to 1,000 mm
∗1
10 mm to 998 mm
10 mm or more
0.05 mm or more
0.1 mm or less
Glassine paper
Roll (Inside)
Cut mode
10 mm to 1,000 mm
-
-
-
-
-
Roll (Inside/outside)
Fanfold