Toshiba B-SX600 SERIES Owner's Manual page 89

■ A blank page (label) is ejected.
Possible causes
The print tone is too low.
The print surface of the loaded
media faces down.
The ink side of the loaded
ribbon faces inside.
Thermal transfer
(normal media)
without loading a ribbon.
The ribbon is
properly.
■ The loaded ribbon is torn or ejected with the media.
Possible causes
The loaded ribbon is not
Toshiba TEC-approved or
recommended.
The print tone is too high.
The ribbon is
properly.
The loaded ribbon is slack.
The Ribbon Strip Plate is dirty.
Check the print tone. If it is too low, increase it.
⇒
[Help] on the Printing Preferences page in the
Printer Driver Properties
Load the media correctly.
⇒
5. LOADING THE MEDIA
Load the ribbon correctly.
⇒
4. LOADING THE RIBBON
media Check if the thermal transfer media is loaded with
is loaded "THERMAL PAPER" selected.
⇒
5. LOADING THE MEDIA
not loaded Check that the ribbon is loaded when the thermal transfer
printing is performed.
⇒
4. LOADING THE RIBBON
Check that the loaded ribbon is Toshiba TEC-approved or
recommended.
⇒
3. MEDIA AND RIBBON
Check the print tone. If it is too high, decrease it.
⇒
[Help] on the Printing Preferences page in the
Printer Driver Properties
not loaded Load the ribbon properly.
⇒
4. LOADING THE RIBBON
Turn the knob of the Ribbon Take-up Shaft. Take up any
slack in the ribbon.
⇒
4. LOADING THE RIBBON
Clean the Ribbon Strip Plate.
⇒
11.3 Cleaning the Ribbon Separation Plate
Solutions / Reference
Solutions / Reference
12- 3
12. TROUBLESHOOTING