Installation; Connecting The Power Cord - Toshiba BA410T Series Owner's Manual

2. PRINTER SETUP

2.1 Installation

2.2 Connecting the
Power Cord
CAUTION!
As a Power Cord is not
supplied with the printer,
please purchase an approved
on that meets the safety
standard of each country.
(Refer to APPENDIX 2.)
To insure the best operating environment, and to assure the safety of the
operator and the equipment, please observe the following precautions.
•
Operate the printer on a stable, level surface in a location free from
excessive humidity, high temperature, dust, vibration and direct
sunlight.
•
Keep your work environment static free. Static discharge can cause
damage to delicate internal components.
•
Make sure that the printer is connected to a clean source of AC
Power and that no other high voltage devices that may cause line
noise interference are connected to the same mains.
•
Assure that the printer is connected to the AC mains with a three-
prong power cable that has the proper ground (earth) connection.
1. Connect the Power Cord to the printer as shown in the figure below
Power Switch
2. Plug the other end of the Power Cord into a grounded outlet as shown
in the figure below.
Power Cord
[Example of US Type]
2
E2-
ENGLISH VERSION
2.1 Installation
Power Cord
Power Cord
[Example of EU Type]