Table of Contents
Advertisement
4 - Configuration
Certain parameters must be configured before the MSS can function in
the network. EZWebCon is the recommended way to communicate with
and configure the MSS. This chapter shows an additional method of
configuration: the command line interface and MSS command set.
NOTE: Instructions for using EZWebCon are included with the soft-
ware. EZWebCon also has on-line help to assist you with con-
figuration.
4.1 Command Set
The command line interface allows users to enter commands at the Local
prompt to configure, monitor, and use the server. This chapter covers
many of the MSS commands. The full command set is discussed in detail
in Chapter 6, Commands,in the MSS Reference Manual located on CD-
ROM.
NOTE: To return to factory defaults, press and hold the Reset button
while cycling power on the unit, or enter the Initialize Factory
command at the Local> prompt.
4.2 System Passwords
There are two important passwords for the MSS: the privileged password
and the login password. These passwords have default settings and are
discussed in the following sections.
4.2.1 Privileged Password
Only the privileged user can change server or port settings. To become
the privileged user, enter the following command. The default privileged
password is system.
Configuration
Figure 4-1: Set Privileged Command
Local> SET PRIVILEGED
Command Set
4 - 1
Advertisement
Table of Contents
