Cleaning - AGFA DR 100e User Manual

Cleaning

To clean the exterior of the equipment:
1. Stop the system.
2. Wipe the exterior of the device with a clean, soft, damp cloth. Use a mild
soap or detergent if required. Do not use any corrosive, dissolving or
abrasive cleaning or polishing agents. Make sure no liquid gets in the
device.
Using unsuitable cleaning agents or methods can damage the property
when surface becomes dull and brittle (e.g. alcohol-containing agents).
3. Start up the system.
Topics:
• Cleaning chromed parts
• Cleaning plastic surfaces
• Cleaning enemaled or aliminum parts
Cleaning chromed parts
Chromed parts must be cleaned only with a dry woolen cloth. Do not use
polishing abrasives. To protect the finish, use a nonabrasive wax.
Cleaning plastic surfaces
Plastic surfaces must be cleaned only with soap and water. When using other
cleaning agents (for example with a high alcohol content), the material can
become opaque or can break.
Cleaning enemaled or aliminum parts
Enameled parts and aluminum surfaces must be cleaned only with a damp
cloth and a mild detergent and then with a dry woolen cloth. Never use
DR 100e (Digital Radiography) | Introduction | 49
CAUTION:
Wet cleaning of the equipment while it is connected to the
electric circuit includes the risk of electric shock and of short
circuit.
CAUTION:
Clean the equipment with only a little moisture.
Note: Do not open the equipment for cleaning. No components
inside the device require cleaning by the user.
0365B EN 20181015 0853