Three-Phase Installation - Riello Hi, Comfort 100 Installer And User Manual

2.5

Three-phase installation

Preparation
Before installing the device
Check that the thermostat is compati-
ble with the boiler (see boiler installer
manual).
The wireless Hi, Comfort T100 ther-
mostat can be installed anywhere,
however the most suitable place
should be chosen taking into ac-
count the following:
− Avoid draughts (A).
− Do not install above sources of
heat (B).
− Avoid direct sunlight (C).
− Position at the appropriate
height (D).
SET ESC
PROG MODE
RESET
A
SET ESC
PROG MODE
RESET
C
Wireless installation does not re-
quire any wiring, making the pro-
cess very simple.
The Hi, Comfort T100 thermostat can
also be installed with wiring, to replace
any existing thermostat, provided com-
patibility is checked in advance.
Before installing the boiler control unit
(WiFi Box), disconnect the boiler from
the power supply.
Installation
SET ESC
PROG MODE
RESET
B
SET
ESC
PROG
MODE
RESET
1,5m
D
36
The following tools are required:
− Phillips screwdriver
− Small slotted screwdriver
− Pliers and wire strippers
Installing the Hi, Comfort T100
Remove the Hi, Comfort T100 from
its base;
Fix the Hi, Comfort T100 base to the
wall or electrical box using the screws
provided.
Using screws other than those PROVID-
ED may compromise the correct closure
of the plastic. Make sure that the screw
head is correctly inserted in the hole.