Three-Phase Installation - Riello BeSMART Installer And User Manual

2.5

Three-phase installation

Preparation
Before installing the device
Check that the thermostat is com-
patible with the boiler (see boiler
installer manual).
The wireless BeSMART thermostat
can be installed anywhere, however
the most suitable place should be cho-
sen taking into account the following:
− Avoid draughts (A).
− Do not install above sources of
heat (B).
− Avoid direct sunlight (C).
− Position at the appropriate
height (D).
SET ESC
PROG MODE
RESET
A
SET ESC
PROG
MODE
RESET
C
Wireless installation does not re-
quire any wiring, making the pro-
cess very simple.
The BeSMART thermostat can also
be installed with wiring, to replace
any existing thermostat, provided
compatibility is checked in advance.
Before installing the boiler control
unit (WiFi Box), disconnect the boiler
from the power supply.
SET ESC
PROG MODE
RESET
B
SET
ESC
PROG MODE
RESET
1,5m
D
37
Installation
The following tools are required:
− Phillips screwdriver
− Small slotted screwdriver
− Pliers and wire strippers
Installing the BeSMART
Remove the BeSMART from its base;
Fix the BeSMART base to the wall
or electrical box using the screws
provided.
Using screws other than those PRO-
VIDED may compromise the correct
closure of the plastic. Make sure that
the screw head is correctly inserted
in the hole.