Riello Hi, Comfort 100 Installer And User Manual page 75

to confirm.
The boiler RF receiver auto-configures
to normal operating mode.
9
The light indicators on the boiler
RF receivers could differ from what
is indicated in section "4 Alarms
and operating statuses" to page
77
9
This may take up to 2 minutes,
after which the Hi, Comfort T100
automatically returns to the HOME
screen.
Should the link not be successful, please
contact the Authorised Service Centre.
NOTE
When replacing the WiFi Box it is nec-
essary to repeat the linking again be-
tween the boiler RF receiver and the
WiFi box.
Linking the RF
Hi, Comfort T100
The Hi, Comfort T100 programmable
thermostat can be linked to a wireless
receiver if you want to replicate the re-
lay functionality on the thermostat in
a remote zone (e.g. zone valve), which
is not accessible with a cable (wireless
access).
Follow the procedure below to link
them:
Press the prismatic dome clear LED but-
ton on the boiler RF receiver and hold
for 5 seconds until the green and red
LEDs slow flash (1 seconds) at the same
time (once linked the flash returns to
normal).
9
The light indicators on the boiler
RF receivers could differ from what
is indicated in section "4 Alarms
and operating statuses" to page
77
From the Hi, Comfort T100 HOME
screen, press the ESC/MODE button and
hold for 5 seconds to display the follow-
receiver to the
ing (alternating) information:
EXAMPLE OF LINKED HI, COMFORT T100
1
2
SET
PROG
RESET
1 Channel (usually 11)
2 Address (usually 00)
3 Thermostat ID (unequivocal, also
shown on the app/server)
4 number of the thermostat as-
signed by the WiFi Box (in the event
of several linked thermostats) –
identifying the zone.
75
ESC
MODE
4
ESC
MODE
3