3.15 Resetting The Wifi Box - Riello Hi, Comfort 100 Installer And User Manual

EXAMPLE OF LINKED HI, COMFORT T100
SET
PROG
RESET
5 number of
(Hi, Comfort T100)
Checking the
to the thermostat in the vent of
a multizone (several thermostats
(paired with a WiFi Box
Put the thermostat in RF pairing
mode by pressing the MODE button
for 5 seconds. Press the FORWARD
button once: the number that ap-
pears in the position under address
(2) indicates the number assigned
to the thermostat (or identifying the
zone served by the thermostat).
Press PROG to exit.
To complete the link, press the
SET/PROGRAM button or wait for
Hi, Comfort T100 to return to the
.HOME screen
9
This may take up to 2 min-
utes, after
Hi, Comfort T100 automatically
returns to the HOME screen.
Should the link not be successful,
please contact the Authorised Service
Centre.
NOTE
When replacing the WiFi Box it is
necessary to repeat the linking be-
5
ESC
MODE
the transmitter
number assigned
which the
tween the zone RF receiver and
Hi, Comfort T100

3.15 Resetting the WiFi Box

To perform a full reset of the WiFi Box,
deleting the full list of coupled devic-
es (thermostats and receivers):
− press the clear prismatic
round LED button (A) on the
WiFi Box and hold for 5 sec-
onds until the green and red
LEDs both start to flash slowly
(1 sec).
− press the Smart Link button
on the WiFi Box once using a
suitable instrument
The clear LED remains off for 1 second
to confirm the operation was suc-
cessful.
At the end of this operation the link-
ing should be carried out again be-
tween:
− WiFi Box and thermostats
− Zone RF thermostats and re-
ceivers.
76