General Information; General Notices - Riello Hi, Comfort 100 Installer And User Manual

1

GENERAL INFORMATION

1.1

General notices

Please read this manual before install-
ing and using the device.
9
Risk of electric shock. This device
should be installed by a qualified
professional and in line with the
standards in force for electrical in-
stallations. Always disconnect the
power supply before installing.
9
Note to the installer:
− Most of the product parame-
ters are factory set. If the de-
vice is activated without a WiFi
connection, the date and time
should be set on the thermostat
as a minimum (this information
is wiped every time the batteries
are removed and if not updated
via the web). All other settings
– such as linking the receiver
and the transmitter (for the WiFi
Box), usage mode and tempera-
tures – are pre-configured.
9
These instructions must be read
together with the sections of the
boiler manual regarding the room
thermostat/boiler remote control.
It is recommended that the device
be installed by qualified techni-
cians.
9
The Hi, Comfort T100 should be
installed in the most accessible
room for you as regards controlling
the room temperature (usually the
living room).
9
As per the
Hi, Comfort T100 should be po-
sitioned 1.5 m from the floor to
make sure that you can easily read
the display.
9
The Hi, Comfort T100 is powered
by 2 x AA batteries.
standards, the
9
The Hi, Comfort T100 must be
kept away from sources of heat
or air currents as these may affect
the accuracy of the readings from
the incorporated room sensor.
9
Do not open the Hi, Comfort T100
for any reason, unless to replace
the batteries; it does not require
any maintenance to operate.
9
Do not press on the liquid crystal
display glass as this may damage
the glass and cause problems
with reading the display.
9
To clean the display, use a dry
cloth only. Any seepage would
damage the liquid crystal display.
9
With the WiFi Box connected in ON/
OFF mode to the boiler or another
appliance via cable, should all of
the thermostats be faulty or the
batteries be flat, the Box switch-
es OFF (after 12 minutes) if it was
ON, or it remains OFF (no heating/
cooling heat request). From the
app, you can manually force the
WiFi Box relay on or off.
9
With the WiFi Box connected in
OTBus mode to the boiler via ca-
ble, should all the thermostats
be faulty or the batteries flat, the
Box will remain in the last oper-
ating mode. The boiler (in heating
mode) can be forced on and off
manually using the APP.
9
With the Hi, Comfort T100 con-
nected (ON/OFF) to the boiler or
another device via cable, should
all the thermostats be faulty or
the batteries flat, the thermostat
relay will remain in the last oper-
ating mode.
9
Should the power supply to the
WiFi Box connected in ON/OFF
mode fail, the Box remains in the
4