Setup Menu 2Nd Level; Limitations; Operation (Setup Menu 2Nd Level) - Fronius TransSteel 2700c MultiProzess Operating Instructions Manual

Setup Menu 2nd Level

Limitations

The following restrictions occur in relation to the Setup menu 2nd level:
Setup menu 2nd level cannot be selected:
-
-
-
-
-
If level 2 of the Setup menu is selected, the following functions are not available,
even in robot mode:
-
-
-
-
-
Operation To access the 2nd level of the Setup menu:
(Setup Menu 2nd
Level)
1
2
3
4
Adjusting parameters
1
114
during welding
if the "Gas test" function is active
if the "Wire threading" function is active
if the "Wire withdrawal" function is active
if the "Gas purging" function is active
Welding start-up - the "Power source ready" signal will not be emitted for ro-
bot mode
Gas test
Wire inching
Wire withdrawal
Gas purging
2T
+
4T
+
2T
+
4T
+
Press the "Process" button to select
MANUAL
SYNERGIC
the "MIG/MAG standard synergic
welding" process
The control panel is now located in the
MANUAL
SYNERGIC
Setup menu of the "MIG/MAG stand-
ard synergic welding" process - the last
selected setup parameter is displayed.
Select the "2nd" setup parameter us-
ing the left-hand selection dial
The control panel is now located in the
MANUAL
SYNERGIC
2nd level of the Setup menu of the
"MIG/MAG standard synergic welding"
process - the last selected setup para-
meter is displayed.
Select the desired setup parameter us-
ing the left-hand selection dial
Change the setup parameter value us-
ing the right-hand selection dial