Parameters For Mma Welding; Parameters For Tig Welding - Fronius TransSteel 2700c MultiProzess Operating Instructions Manual

2nd
Parameters for
HCU
MMA Welding
Hti
Ast
FAC
2nd
Parameters for
F-P
TIG welding
tUP
112
- when "PrG" appears on the digital display, the power source has been re-
set
When the power source is reset, the majority of the applied settings are
deleted. The following values remain:
- Welding circuit resistance and welding circuit inductivity
- Country-specific setting
Second level of the Setup menu (see "Setup Menu 2nd Level")
HotStart current
Unit: %
Setting range: 100 - 200
Factory setting: 150
Hot current time
Unit: seconds
Setting range: 0 - 2.0
Factory setting: 0.5
Anti-stick function
Unit: -
Setting range: On, OFF
Factory setting: On
Reset power source to factory settings
Press and hold one of the "Parameter selection" buttons for two seconds
to restore the factory settings
- when "PrG" appears on the digital display, the power source has been re-
set.
When the power source is reset, the majority of the applied settings are
deleted. The following values remain:
- Welding circuit resistance and welding circuit inductivity
- Country-specific setting
Second level of the Setup menu (see "Setup Menu 2nd Level")
Pulse frequency
Unit: Hertz
Setting range: OFF; 1 - 990
(up to 10 Hz: in 0.1 Hz increments)
(up to 100 Hz: in 1 Hz increments)
(over 100 Hz: in 10 Hz increments)
Factory setting: OFF
UpSlope
Unit: seconds
Setting range: 0.01 - 9.9
Factory setting: 0.5