Setup Menu 2Nd Level; Limitations; Operation (Setup Menu 2Nd Level) - Fronius TransSteel 4000 Pulse Operating Instructions Manual

Setup Menu 2nd Level

Limitations

The following restrictions occur in relation to the Setup menu 2nd level:
Setup menu 2nd level cannot be selected:
-
-
-
-
-
If level 2 of the Setup menu is selected, the following functions are not available, even in
robot mode:
-
-
-
-
-
Operation (Setup Accessing the 2nd level of the Setup menu:
Menu 2nd Level)
To change a parameter:
90
during welding
if the "Gas test" function is active
if the "Wire threading" function is active
if the "Wire withdrawal" function is active
if the "Gas purging" function is active
Welding start-up - the "Power source ready" signal will not be emitted for robot mode
Gas test
Wire inching
Wire withdrawal
Gas purging
2T
4T
2T
+
4T
2T
4T
2T
+
4T
Press the "Process" button to select
MANUAL
1
STD SYNERGIC
the "MIG/MAG standard synergic wel-
PULSE SYNERGIC
ding" process:
Press and hold the "Mode" button
2
Press the "Process" button
MANUAL
3
STD SYNERGIC
PULSE SYNERGIC
Release the "Mode" and "Process"
MANUAL
4
STD SYNERGIC
buttons
PULSE SYNERGIC
Select the "2nd" setup parameter using
5
the left-hand selection dial
Press and hold the "Mode" button
6
Press the "Process" button
MANUAL
7
STD SYNERGIC
PULSE SYNERGIC
Release the "Mode" and "Process"
MANUAL
8
STD SYNERGIC
buttons
PULSE SYNERGIC
Select the desired setup parameter
1
using the left-hand selection dial
Alter the setup parameter value using
2
the right-hand selection dial