Pylontech US5000 Series Operation Manual page 32

Solution: to move battery to the normal operating temperature range
between 0°C and 50°C.
c) Current: If current exceeds 90A, battery protection will turn on.
Solution: Check whether current is too large or not, if it is, change the
settings on power supply side.
d) High Voltage: If charging voltage above 54V, battery protection will turn on.
Solution: Check whether voltage is too high or not, if it is, to change the
settings on power supply side. And discharge the module.
e) Low Voltage: When the battery discharges to 44.5V or less, battery
protection will turn on.
Solution: Charge the battery till the red light turns off.
f) Cell voltage high. The module voltage is lower than 54V, SOC LED does not
all on. When discharge the module protection disappear.
Solution: keep charge the module by 53-54V or keep the system cycle. The
BMS can balance the cell during cycling.
3) Unable to charge and discharge with red LED on. The temperature is 0~50
degree. Use charger to charge, not possible. Use load to discharge, not
possible.
g) Under permanent protection. The single cell voltage has been higher than
4.2 or lower than 1.5 or temperature higher than 80 degree. Solution:
Switch off the module and contact your local distributor for repair.
4) Unable to charge and discharge without red LED on. The temperature is
0~50 degree. Use charger to charge, not possible. Use load to discharge,
not possible.
h) Fuse broken.
Solution: Switch off the module and contact your local distributor for repair.
5） Buzzer rings and all LED
i) High voltage protection.
Cell voltage higher than 4V or module voltage higher than 55.5V.
Solution: Battery system requires properly established communication
with inverter and correctly settings on inverter to run safely. Check the
setting of the inverter or charger, the charge voltage shall be 53.2~52.5Vdc;
flash
29