Useful Scanning Tips; Recommended Ezscan Workflow - Vatech EzScan-i User Manual

7.3 Useful Scanning Tips

Always take care when scanning to:
• Stay in contact with or close to the teeth
(recommended distance from tip to tooth is 0-12 mm)
Scan slowly and smoothly, to avoid interrupting the 3D reconstruction
•
(minimum 1 second per tooth)
Keep teeth in the center of the field of view
•
• Avoid scanning lips, cheeks, tongues, gloves, etc.
• Do not hesitate to reset the scan if necessary
Begin your scan by starting on the arch of chosen restoration. If you have selected to
scan the antagonist, you may start by scanning either arch.
IMPORTANT: Before each patient, the scanner's removable tip
must be sterilized using an autoclave. See below: Section 9.2
Cleaning and Sterilizing Tips

7.4 Recommended EzScan Workflow

Before launching a scan,
computer via the USB 3.0 cable provided and the EzScan-I software is running.
Make sure the computer on which the EzScan-i software is installed is connected to
an external power source.
See above: section 3.2 Connecting the EzScan
IMPORTANT: If using a laptop computer, make sure the power
supply is connected to a power outlet and not running on battery
power. Failure to do so will mean that the scanner will not have
sufficient power to produce images.
On laptop computers, battery settings in Windows should be
configured to high performance mode only, with no battery
saving option (Settings/System/Battery).
Page 44
.
make sure the EzScan Scanner is correctly connected to the
User Manual