Table of Contents
Advertisement
7.4
Useful Scanning Tips
Keep close to teeth
•
(recommended distance from tip to tooth is 0-12 mm)
Scan slowly and smoothly, to avoid interrupting the 3D reconstruction
•
(minimum 1 second per tooth)
•
Keep teeth in center of the field of view
Angle the scanner tip
•
(bite alignment is based on gingival data)
Avoid extraneous items (lips, cheeks, tongues, gloves, etc.)
•
Do not hesitate to reset scan if necessary
•
Begin your scan by starting on the arch of chosen restoration. If you have selected to
scan the antagonist, you may start by scanning either arch.
IMPORTANT: Before each patient, the scanner's removable tip must
be sterilized using an autoclave. See below: Section 9.2
and Sterilizing Tips
7.5
Before You Scan: Important Notice
Before launching a scan:
Make sure the
•
the USB 3.0 cable provided and the EzScan-I software is running.
•
Make sure the
connected to an external power source.
Page 48
to take in as much gingiva as possible
.
EzScan Scanner is correctly connected to the computer via
computer
IMPORTANT: If using a laptop computer, make sure the power supply
is connected to a power outlet and not running on battery power.
Failure to do so will mean that the scanner will not have sufficient
power to produce images.
On laptop computers, battery settings in Windows should be
configured to high performance mode only, with no battery saving
option (Settings/System/Battery).
on which the EzScan-i software is installed is
Cleaning
User Manual
Advertisement
Table of Contents
